Menu
The holes for the posts must be dug 600mm deep and approximately 350mm x 350mm wide. The centre to centre measurement of the holes must be 3076mm apart to install a standard 3 000mm width panel.
Using a fish line to ensure that you get a straight line and a measuring tape to determine the distance between the holes, plant the posts in the holes. Use a spirit level to make sure your posts are straight and upright. Each hole will require 1 bag of ready mix concrete. Let the concrete cure for 24 hours.
Take the 2 horizontal cross members and place them on the floor. Bolt on the two end pailings ensuring that the flat surface of the cross member faces upwards so that rain water does not collect in the angle. See picture of cross member.
Now take the partially assembled panel and bolt the panel to the posts using the brackets as shown below without tightening too much.
Ensure that the desired ground clearance has been obtained and that the panel is level.
Now tighten the bolts on the brackets and bolt on the remaining pailings taking care that the pailing is not flattened due to excessive tightening.
Once satisfied that the panel is assembled correctly you may snap off the anti-vandal nuts using a ring spanner or vice grip.
We have 32 branches across South Africa.
Find a branch near you
info@sltrading.co.za
Contact a branch directly
Customer Care: 0860 10 27 99
Head Office : 27 (11) 553 8500
Address: Erf 146, Tedstone Rd, Wadeville, Gauteng, 1428, RSA
Phone: 011 824 1800
Postal Address: PO Box 79458, Senderwood 2145
Email: steelandtube@sltrading.co.za
Address:
Cnr Dan Jacobs St & Vereeniging Rd, Alrode, Gauteng, RSA
Phone:
011 917 0778
Postal Address:
PO Box 79458, Senderwood 2145
Email: RogerM@sltrading.co.za
Cell:
+27 (0) 72 398 0388
Farhana Tayob
Civils and Exports Manager for pipes and fittings
Address:
Cnr Dan Jacobs St & Vereeniging Rd, Alrode, Gauteng, RSA
Phone:
011 917 0778
Postal Address:
PO Box 79458, Senderwood 2145
Email:
FarhanaT@sltrading.co.za
Cell:
+27 (0) 66 586 6703
